Guide: (Please read me)
This is the list of all 3D prints we are trying to finish before the end of the semester. Generally, we want to be printing parts as often as possible so we can finish this list ASAP. If you can, please print the next “not started” print in numerical order. The list is automatically sorted in numerical order, so it should be the next one that says “not started.” Although the “not designed yet” parts are high priority, we cannot start printing them until we have designed them. Use the listed infill%, wall loops, and resolution settings. For infill type, USE GYROID. Gyroid is better because it is slightly stronger, and most importantly it produces a single continuous internal volume rather than portioning it off into segments. This is very useful because we want to uniformly fill our 3D prints with water by drilling holes in them, but traditional infill would require one hole per volume section. Until we get other filament colors, we will only use white. PLA prints can be in either PLA or PETG. PETG prints MUST be in PETG.
Remember to use the specified settings and USE GYROID!